Unity volume on the Rooster?

Tonal shaping & volume boosting delivered with germanium love.

Moderator: The Captain

User avatar
Zacharia Matilda
Posts: 912
Joined: Mon Nov 21, 2011 6:55 pm
Location: Maine, USA

Re: Unity volume on the Rooster?

Post by Zacharia Matilda » Thu May 24, 2012 1:34 pm

Thanks for the numbers, gents. Very helpful. Takes the guesswork out of the whole process. Much appreciated! :tu:
"What we need is a love bomb. A 100% gold plated, purified love bomb."
User avatar
Posts: 5400
Joined: Wed Aug 27, 2008 4:28 am
Location: Isthmus Duwamps

Re: Unity volume on the Rooster?

Post by psycho*daisies » Fri May 25, 2012 3:24 pm

6.66 volts? That's the Captain for ya! haha
jerms wrote:I just checked an unmessed with rooster and it lets a hair of the signal thru fully CCW.... I think it's normal for them to cut the signal nearly out.... If you think the trimmer has been messed with, and you have a volt meter to hand, you can check the volt reading for bias on the right hand lead of the .01 capacitor that's horizontal at the top of the board (The lead closest to the transistor), with the boost fully clockwise it should be 6.6 volts DC, IIRC..... Maybe the captain can weigh in on this to verify.......

Edit: just checked my assumed unmessed with rooster and got 6.65..... With a battery voltage of 9.41
If you struggle baby,
It only tightens up...
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests